INSTEON SwitchLinc 2-Wire Dimmer (RF) (2474DWH) Manual - Manual (Page 10)

Page 10 of 15 2474DWH- Rev: 1/21/2014 7:30 AM
Adjust Local Settings (optional)
Local On-Level
The local on-level is the brightness that the SwitchLinc will come on when turned on at the SwitchLinc
paddle, with the default level at 100%. Local on-level can be set to any one of 32 fixed brightness levels
(3% to 100%) or “resume bright” (brightness prior to last being turned off).
1) Adjust light to desired brightness (or off for resume dim).
2) Tap the Set button.
SwitchLinc will beep.
3) Test by tapping SwitchLinc on and off.
The light should come on at the programmed on-level (or previous level prior to turning off for
resume dim).
Local Ramp Rate
The local ramp rate is the time it takes for SwitchLinc to reach 100% brightness (from off) when controlled
at the paddle. The default ramp rate is 0.5 seconds, but it is adjustable from instant-on to 9 seconds
(using Set button) or up to 8 minutes (with software).
The ramp rate is set up using the light’s brightness level as the indicator for the ramping speed: the
brighter the light, the faster the ramp rate. Refer to this table to help you set your desired ramp rate:
Brightness Level Ramp Rate in Seconds
90-100% 0.1
77-86% 0.2
65-74% 0.3
52-61% 2.0
39-48% 2.0
26-35% 4.5
13-23% 6.5
1-10% 8.5
1% 9.0
1) Adjust the connected light(s) to the brightness corresponding with your desired ramp rate (see table
above).
2) Quickly double-tap SwitchLinc’s Set button.
SwitchLinc will beep.
3) Test ramp rate settings but tapping SwitchLinc or controller button on and off.
The connected light(s) will turn on and off at the programmed ramp rate(s).
4) If the ramp rate is not as desired: