INSTEON SwitchLinc Relay (2476S) Manual - Manual (Page 17)

Page 17 of 21 Rev: 1/21/2014 7:15 AM
Scene Commands Supported as
Controller
On Fast-on
Off Fast-off
Dim Brighten
Scene Commands Supported as
Responder
On Fast-on
Off Fast-off
Dim Brighten
Software Configurable Yes
RF Range 915 MHz
X10 Support Yes
X10 Addresses 1 optional (ships unassigned)
INSTEON Device Category
Dimmer switches
INSTEON Device Subcategory
Mechanical
Mounting
Mounts in single or multiple-ganged wall box. Control 200W
less load for each immediately adjacent SwitchLinc Dimmer
installed. For example, 600 W load control becomes 400 W
with another dimmer to the immediate right or left. Use a triple-
gang box with a mechanical switch in the center to avoid de-
rating.
Wire Nuts
4 included
Wires
line (black)
load (red)
neutral (white)
ground (bare copper)
Case Color White
Set Button Yes
Beeper Yes
LED Dual-color red/green setup LED, 9 white LEDs
Dimensions 4.1" H x 1.8" W x 1.2" D
Weight 3.6 oz.
Operating Environment Indoors
Operating Temperature Range 32°F to 104°F
Operating Humidity Range Up to 85% relative humidity
Electrical
Voltage 120 volts AC +/- 10%, 60 Hertz, single phase
Maximum Dimmer load 600 watts (uses 12-Amp triac dimmer)
load Type(s) Wired-in incandescent lighting devices
Retains all settings without power Non-volatile EEPROM
Standby power consumption 0.59 watts