beautypg.com

Make switchlinc a controller, Remove switchlinc as a controller, Make switchlinc a responder – INSTEON SwitchLinc Relay (2476S) Manual User Manual

Page 11: Remove switchlinc as a responder

background image

Page 11 of 21 Rev: 1/21/2014 7:15 AM

Make SwitchLinc a Controller

Follow the steps below to link SwitchLinc as a controller of another INSTEON device.

1) Press and hold SwitchLinc Set button until it beeps (about 3 seconds)

Status LED will blink green
You will have 4 minutes to complete the next steps before linking mode times out

2) Set the responder to the state you want to activate from SwitchLinc (e.g., on, 50% brightness, off)

If the responder is a multi-scene device such as a KeypadLinc, tap the scene button you want to
control so its LED illuminates

3) Press and hold the responder’s Set button for 3 seconds

SwitchLinc will double-beep and status LED will stop blinking

Responder LED will stop blinking and it may double-beep

4) Confirm that linking was successful by tapping SwitchLinc paddle on and off

The responder will respond appropriately

5) If you want SwitchLinc to control multiple responders, repeat steps 1-4 with each additional responder

or see Add Multiple Scene Responders.

Remove SwitchLinc as a Controller

If you are disabling or removing any INSTEON responders that SwitchLinc controls, it is very important
that you unlink each responder from SwitchLinc before disabling or removal. Otherwise, SwitchLinc will
repeatedly try to send commands, causing delays in your INSTEON network’s inter-device
communication.

1) Press and hold SwitchLinc Set button until it beeps (about 3 seconds)

Status LED will blink green

2) Again, press and hold SwitchLinc Set button until it beeps (about 3 seconds)

Status LED will blink red
You will have 4 minutes to complete the next step before unlinking mode times out

3) Press and hold the responder Set button for 3 seconds

SwitchLinc will double-beep and status LED will stop blinking

4) Confirm that unlinking was successful by tapping SwitchLinc paddle on and off

The responder will no longer respond

Make SwitchLinc a Responder

Follow the steps below to make SwitchLinc a responder of another INSTEON controller.

1) Press and hold the controller Set or scene button until it beeps and/or LED blinks (about 3 seconds)

If the controller is a multi-scene device such as a KeypadLinc, press and hold the scene button
you want to use as the controller
Controller LED will blink
You will have 4 minutes to complete the next step before linking mode times out

2) Use SwitchLinc to set the connected load to the state you want to activate from the controller (e.g.,

on, 50% brightness, off)

3) Press and hold SwitchLinc Set button until it double-beeps (about 3 seconds)

SwitchLinc status LED will flash once, then turn on solid

4) Confirm that linking was successful by tapping the controller button on and off

The load connected to SwitchLinc will respond appropriately

Remove SwitchLinc as a Responder

If you are going to disable or remove SwitchLinc, it is very important that you unlink it from all controllers.
Otherwise, the controllers will try sending commands to SwitchLinc, causing delays in your INSTEON
network’s inter-device communication.

This manual is related to the following products: