Hach-Lange GANIMEDE N - Manual (Page 59)

59
Appendix A Interface protocol
RS 232 interface for the analysis unit and open-loop control unit.
The RS 232 C interface has a 9-pole sub-D socket and a 9-pole sub-D connector. The
interface is connected to the serial interface (COM) of the computer (LIMS system) with
the PC cable (XLH 917).
Table 6 RS 232 I/O card connection assignment
9-pole SUB-D Socket 9-pole SUB-D Connector
PIN PIN
GND 5 GND 5
RxD 3 RxD 2
TxD 2 TxD 3
RTS 8 RTS 7
CTS 7 CTS 8
Table 7 RS 232 software description
ID Description
ID001 Start of a block
ID101 Parameters
ID102 Name
ID103 Users
ID104 Measurements (single/double)
ID107 Calibration (two-point/e.g. standard curve 1)
ID108 Sample tray measurement data
ID110 Method 0 name (total/low)
ID111 Standard absorbance 2 (two-point calibration)
ID112 Standard concentration 2 (two-point calibration)
ID114 Standard curve linear equation
ID115 Standard curve measurement data
ID116 Standard absorbance 1 (two-point calibration)
ID117 Standard concentration 2 (two-point calibration)
ID118 Standard curve lowest concentration
ID119 Standard curve highest concentration
ID120 Method name 1 (ortho/high)
ID121 Standard absorbance 2 (two-point calibration)
ID122 Standard concentration 2 (two-point calibration)
ID124 Standard curve linear equation
ID125 Standard curve measurement data
ID126 Standard absorbance 1 (two-point calibration)
ID127 Standard concentration 2 (two-point calibration)
ID128 Standard curve lowest concentration
ID129 Standard curve highest concentration
ID130 Start of a sample
ID131 Position
ID132 Sample name