Lift off the cover, Table 2-1: p3 and p4 jumper settings, For reassembly, reverse steps 1 through 6 – Clear-Com EF-701M User Manual
Page 33
E F - 7 0 1 M I N T E R F A C E
2 - 1 1
6.Lift off the cover.
7.Make the necessary adjustments of jumpers P3 and P4 (shown in the following table).
To set a jumper to the closed position, plug it onto both pins. To set a jumper to the
open position, plug it onto only one of the pins.
Table 2-1: P3 and P4 jumper settings
8.For reassembly, reverse steps 1 through 6.
Note: The potentiometer (R13) is used to factory tune the 20-kHz call-signal detection
circuitry. It should be adjusted only by qualified personnel.
BAUD 1
BAUD 2
RATE
Open
Open
19.2 kBaud
Closed
Open
9.6 kBaud
Open
Closed
4.8 kBaud
Closed
Closed
2.4 kBaud
See also other documents in the category Clear-Com Accessories communication:
- CS-702 (36 pages)
- MS-702 (32 pages)
- MS-704 (40 pages)
- RCS-2700 (54 pages)
- SB-704 (42 pages)
- RS-701 (2 pages)
- RS-702 (3 pages)
- RS-601 (No longer available) (60 pages)
- RS-603 (No longer available) (58 pages)
- RS-601 (No longer available) (46 pages)
- RS-602 (No longer available) (56 pages)
- PK-7 (14 pages)
- PS-702 (28 pages)
- PS-704 (34 pages)
- RM-702 (42 pages)
- RM-704 (46 pages)
- HB-702 (24 pages)
- KB-701 (24 pages)
- KB-702 (32 pages)
- V-BOX (2 pages)
- TW-12C (20 pages)
- IF4W4 (20 pages)
- TW-47 (30 pages)
- TWC-701 (18 pages)
- PRC-2 (24 pages)
- PTX-3 (32 pages)
- AB-120 (35 pages)
- AX-704 (30 pages)
- FL-7 (16 pages)
- WP-2 (1 page)
- WP-6 (1 page)
- HMS-4X (2 pages)
- HMS-4X (2 pages)
- HMS-4X (143 pages)
- HMS-4X (197 pages)
- HRM-4X (2 pages)
- Eclipse HX-PiCo (86 pages)
- Eclipse HX-PiCo (4 pages)
- Eclipse HX-PiCo (70 pages)
- Eclipse HX-Delta (2 pages)
- Eclipse HX-PiCo (290 pages)
- Eclipse HX-Delta (143 pages)
- Eclipse HX-Median (145 pages)
- Eclipse HX-PiCo (186 pages)