Remote rcu-67 front-panel jack (9), Rear panel, Address switch (1) – Clear-Com RCS-2700 User Manual
Page 18: Remote rcu-67 front-panel jack (9) -10, Rear panel -10, Address switch (1) -10
R C S - 2 7 0 0 S O U R C E A S S I G N M E N T P A N E L
1 - 1 0
If the Code button is released for three seconds before going to the next step,
the unlocking procedure is cancelled and the RCS-2700 remains locked.
3. When the correct code appears, press and release the Lock button.
Within a second or two, the Locked light will turn off and the current preset
number will appear on the display.
The Preset button on the RCS-2700 is now unlocked and you can select a new
preset. To lock the Preset button again, and keep the same unlock code, simply
press and hold the Lock button for three seconds.
REMOTE RCU-67 FRONT-PANEL JACK (9)
An RCU-67 Remote Control Unit can be plugged into the front-panel jack to
provide additional programming capability. The RCU-67 connects to the
RCS-2700 unit through Category-5 cable with RJ-45 connectors. The
RCS-2700 unit will recognize the presence of the RCU-67 and will begin
communicating with it after it has been plugged in for a few seconds.
While an RCU-67 is plugged into the front-panel jack, communication with a
PC or with a rear-panel connected RCU-67 will be suspended.
REAR PANEL
Figure 1-7: RCS-2700 Rear Panel
ADDRESS SWITCH (1)
An RCS-2700 unit’s address switch is set when it is installed and should not be
changed unless the system is being reinstalled or reconfigured.
The position of this switch can be determined from the RCS-2700 unit’s
front-panel display. If the address switch is set to “M,” then the unit functions as
13
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
DESTINATION POWER
1 2 3 4 5 6 7 8
SOURCE POWER
SCE
RCS PWR
13
DESTINATIONS
14
15
16
17
18
19
20
21
22
23
24
1
DESTINATIONS
2
3
4
5
6
7
8
9
10
11
12
1
SOURCES
2
3
4
5
6
7
8
SOURCE EXPANSIONS
14
15
16
17
18
19
20
21
22
23
24
1
SOURCE EXPANSIONS
2
3
4
5
6
7
8
9
10
11
12
MTX
CONT
DATA
LINKS
PC SERIAL
PORT
RCU-67
M
4
2
A
1
3
5
B
ADDRESS
1 2 3
8
4 5 6 7
TERMINATION
SWITCHES
ON
OFF
CODE RESET
Address Switch
Remote RCU-67 Jack
PC Serial Port
Data Links
Preset-Select Contact
Code-Reset Button
Termination Switches
1
2
3
4
5
6
7
• If the lock light is on, you
cannot change the preset
from the front panel. For
security reasons you
cannot change the unlock
code either. You must
unlock the unit first.