Preset button (6), Preset configurations (“presets”), Preset button (6) -7 – Clear-Com RCS-2700 User Manual
Page 15: Preset configurations (“presets”) -7
R C S - 2 7 0 0 S O U R C E A S S I G N M E N T P A N E L
1 - 7
PRESET BUTTON (6)
Preset Configurations (“Presets”)
A “preset” is a group of source/destination assignments that you store for current
or future use. The RCS-2700 unit’s memory can store 14 groups of
source/destination assignments. Each group is called a “preset.” Source/destination
assignments are always made within one of the 14 presets. The desired preset must
be specified before making a source/destination assignment.
The number of source/destination assignments within a preset can be as few as
one destination assigned to one source or as many as 72 destinations assigned to
15 sources (in a multi-unit system).
When you receive your system, all 14 available presets are set to a default
configuration in which each destination is assigned to a source in numerical
order, as shown in Figure 1-6. You can then change the source/destination
assignments within each preset to suit your needs.
If at some point you want to set the system back to the default presets, you can
do so by using the Code-Reset button on the rear panel of the RCS-2700. See
“Using the Code-Reset Button” in the Installation Chapter for further
instructions.
Figure 1-6: Default Source/Destination Assignments
You initially program presets using a handheld RCU-67 Remote Control Unit or
a PC with RCS-WIN software. When you have programmed more than one
preset, you can select between presets in one of four ways: with the preset button
on the front panel of the RCS-2700; with a handheld RCU-67 Remote Control
Unit; with a contact closure; or with a PC that has the RCS-WIN software
installed.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1
x
x
x
2
x
x
x
3
x
x
x
4
x
x
x
5
x
x
x
6
x
x
x
7
x
x
x
8
x
x
x
SOURCES
DESTINATIONS