Alliance Laundry Systems Drying Tumbler 70278501R5EN - Manual (Page 26)

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Installation/Operation Supplement
70278501 (EN) 24
Manual Timer Control
MT and RT Control Suffixes
1. Set the HEAT/DRYING timer for the number of
minutes (from 0-60) desired.
2. Set the COOL DOWN/COOLING timer for the
number of minutes (from 0-15) desired.
3. Set the TEMPERATURE selector at HIGH,
LOW or anywhere between these settings.
4. Select reversing or nonreversing cylinder rotation
setting, if applicable.
5. Press the PUSH TO START button in and hold it
in for approximately three (3) seconds. This
starts the tumbler cycle.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the PUSH TO
START button must be pressed in.
6. When the cycle is complete, open door and
remove the laundry.
TMB2173N
Figure 8
TMB2174N
Figure 9
TMB2175N
Figure 10
TMB2145N
Figure 11
10
20
40
30
50
60
0
HEAT
10
5
COOL
DOWN
15
0
HIGH
TEMPERATURE
LOW
TMB2146N
Figure 12
PUSH
TO
START