Software - configuration users, Saving the user code – CAME Rbm84 User Manual
Page 51

cap. <
4
> pag. <
7
>
ENGLISCH
Software - CONFIGURATION USERS
Cap 4
... and then, within 10 seconds,
D- type the number code into the dedicated
keypad on the front panel of PC30 and then
type “E”
"
A- for the TAM and ATOMO remote controls, press
the key to save, sending the signal to the dedicated
area on the front panel of PC30, or
B - for TSP00, move the proximity Card you
want to save to the dedicated area on the front
panel of PC30, or
C- for LT001, swipe the Card to save
along the dedicated groove on the
front panel of PC30.
The code-saving functions described above (A- sending the signal,
B- bringing the Card in proximity to the panel, C- swiping the Card or D- typing the code) must take
place within the time it takes (10”) for the graduated bar in the lower part of the main window to scroll
For the S5000, S6000 and S7000 keyboards however, we are promted to indicate if we want to use
PC30 to save the code; if not, saving must be made by the software (see next page)
... by pressing [YES],
Saving the USER CODE
RBM 84 -Software