Fluid Components International CMF Series Manual Table of Contents - Manual (Page 2)

FlexCOR ä Model CMF Series 4
Fluid Components Intl
Document 06EN003327 Rev. -
The unique SENSORPROM ® flow memory unit contains sensor data and signal converter
settings. The unit is located on the connection board for the signal converter. Immediately on
starting, the signal converter uploads the calibration data and factory settings matching the
sensor and commences measurement. All customer application settings are retained in the
SENSORPROM ® unit. If the signal converter is replaced, the new converter will upload all
previous settings and resume measurement without any need for reprogramming.
1. Product Introduction
1.0 Introduction
FlexCOR ™ mass flowmeters are characterised by simplicity:
Þ Simple to install
Þ Simple to commission
Þ Simple to operate
Þ Simple to maintain
FlexCOR™ coriolis mass flowmeters measure flow in kilograms or pounds. The
measurement is independent of changes in process conditions such as temperature, density,
pressure, viscosity, conductivity and flow profile.
FCI FlexCOR ™ mass flowmeters are for the direct measurement of:
· Mass flow rate
· Total mass
· Density
· Temperature
· Volumetric flowrate
· Total volume
· Fraction flow
· % fraction (e.g. °Brix)
· Total fraction
Typical applications are found in all industries. E.g.:
• Water industry: Dosing of chemicals for waste water treatment.
• Food industry: Dairy products, beer, wine, soft-drinks, fruit juices and pulps.
• Chemical industry: Detergents, pharmaceuticals, acids, alkalies.
• Automotive industry: Fuel injection nozzle testing, filling of a.c.units, ABS brake test.
• Other industry: Filling of gas bottles, furnace control for district heating, paper pulp.
Documentation needs to be consulted.
The user shall be made aware of that, if the equipment is used in a manner not specified by
the manufacturer, the protection provided by the equipment may be impaired.