ELRO FA703IP Plug & play wifi network camera - Manual (Page 20)

20
password at "Password". You can find both codes on the back
of the camera.
• If you want the App to remember your password, move the
box behind "Remember Password" to the right so that "I" is
visible.
• Click on the "Login" button. The screen "Remote Device" shows
G . Here you can see if the camera is connected (ONLINE) or if
it is not connected (OFFLINE).
Your camera has been added to your phone and will appear on
the start screen of your App.
4.2.3. General
• For instructions on placing your camera go to section 4.7.
• For instructions on using your camera with the App go to
chapter 5.
4.3. Install your camera on your PC
• Insert the included CD-ROM into your computer.
• Launch "SYSM Monitor.exe" from the CD-ROM.
• To run through the installation, click on "Next" three times.
• Complete the installation by clicking on "Restart computer".
The IP camera tool is now installed on your computer. You will find
the shortcut on your desktop.
4.2.2. iOS
• Download the App: "Plug2View" from the App Store and
install it.
• Start the App.
The "Login" screen of the App shows E . Here you can log in to
the App, you can register an account and you can download a QR
code scanner.
Registering an account
• Click on "Register", the screen "Register Account" shows F .
• Enter your username at "Username".
• Enter your password at "Password".
• Enter your password once again at "Please enter again".
• Enter your email address at "Email".
• Click on "Done". When the registration is successful, a message
"Register success" is displayed.
• Click on "OK" and then "Login" to return to the "Login" screen.
Scanning QR Code
• Click on "Scan QR Code" and then scan a QR code. This must
entirely fit within the white square.
• Press "Cancel" to go back again without scanning.
Login to the App
• Input the camera code at "Username" and the camera