Burkert Type 8035 - Manual (Page 18)

8.3. operating levels of the device
The device has two operating levels: the Process level and the Con-
figuration level.
The Process level makes it possible:
• to read the flow rate measured by the device and the value of the
totalizers, the main and the daily one.
• to reset the daily totalizer.
• to access the Configuration level.
The Configuration level makes it possible to set the device
parameters.
Table 4: Default settings of the device
Function Default value
LANGUAGE English
UNIT of the flow rate l/s
UNIT of the totalizers litre
Number of decimals 2
K FACTOR 46,60
FILTER Filter 2
ENTER
0......9
+
2)
To reset the daily
totalizer (identified by
a dot after the volume
units).
> 2 s
+
Process level
12.6 l/s
87654 l
231 l.
> 5 s
lANGUAGE
UNit
K-FACtOR
FiltER
tOtAl
END
Configuration level
Process level
2) Possible if the ENTER key is unlocked (see chap. 8.2)
Fig. 12: Diagram of the levels of the device
Once the settings of a parameter is done if you do not want
to adjust another parameter, go to the "END" parameter of
the Configuation level and press
ENTER
to save the settings
and go back to the Process level.
16
Operatingandcommissioning
Type 8025/8035 battery powered
English