Burkert Type 8056 - Manual (Page 25)

SE56
25
6.1* Output 1 functions
6.2* Output 2 functions
6.3* Output 2 functions
6.4* Output 4 functions
6.5* Choice of the function and the range of current output n.1
8.1 Choice of the language: EN= English, IT=Italian, FR= French, SP= Spanish
8.2 Display totilizer mode
8.3 Updating frequency on the display: 1-2-5-10 Hz
8.4 Quick start menu visualization
8.5* Volume totalizer 1 reset
8.6* Volume totalizer 2 reset
9.1* Number of batch cycles to be done to define the value of compensation.
9.2* % limit of compensation threshold
9.3* Compensation value
9.4* Prebatch value
9.5* Auto-batch
9.7* Static consent of batch
9.6* Automatic selection of batch formula
10.1* Enable the calibration of the transmitter
10.2* Transmitter autotest
10.3* Flow rate simulation enabling
10.4 Stand-by of transmitter to reduce the consumption during service operation
10.5 Firmware revision/version
7.1 Choice of the communication protocol for the IF2 device
7.2 Address value of the transmitter
7.3 Speed of the RS485 output (possible choices: 4800, 9600, 19200, 38400 bps)
7.4 Instrument answer delay
11.1 Level 2 access code enter
11.2 Load factory data pre-set
11.3 Load user data saved
11.4 Save user data
11.6 Ks coefficient (only for service purposes)
11.5 Ignore the calibration error during the switch on test
Menu 9 visualized only IF batch is active