Type 8660 control center, Installing the control center – Burkert Type 8660 User Manual
Page 5

Type 8660 Control Center
________________________________________________________
- 5 -
2. Notes on Safety
To ensure that the Control Center functions faultlessly and has a long life, the user
must observe the instructions in this user's manual, and pay attention to the usage
conditions and the allowable data according to the data sheet. Installation and
maintenance personnel must have been trained and authorized to carry out such
activities.
Appropriate measures must be taken to prevent unintended or improper use of the
Control Center, and the resulting detrimental influences on the process. After an
interruption, a defined and controlled restart of the system, as described in the user's
manual, must be carried out.
Secure electrical and fluid isolation devices must be used when the system is being
repaired. Control Center repairs may only be carried out by authorized Bürkert
technicians.
3. Installing the Control Center
The Control Center has the installation format of an auto radio and can be built into
the dashboard without tools, using a mounting frame. It is pushed, together with the
mounting frame, into the installation shaft which is provided for this purpose, and
locks itself in.
Release levers are used to dismount the system, the same as are used for auto
radios. They are entered into the drill holes on the side, until they release the lock.
The Control Center is then pulled out of the installation shaft with the release levers.
External dimension of housing ( W x H x D )
174 mm x 51 mm x 79 mm
External dimension of front panel ( W x H x D)
188 mm x 58 mm x 8 mm
Total depth of system with plug strip
87 mm