Burkert Type 8645 User Manual

Page 4

INSTALLATION

CAUTION!

Danger due to electromagnetic ﬁ elds!

If the FE connectors are not connected, the EMC-law condi-
tions are not adhered to!

Pay attention to the correct positioning of the gaskets
around the electronic and pneumatic components.

•

Start with the ﬁ eld bus / multipole module.
The sequence of modules is random to the right of the
ﬁ eld bus / multipole module.

A) Wall mounting

FE contact
(connect via FE rail)

8a FE rail

Screw (separate FE
connection)

10 Mounting straps

Proceed with wall mounting as follows:

ﬁ rst, fasten the ﬁ eld bus / multipole module to the two
mounting points on the wall

remove the blue connection bracket

unbolt the 3 pinlocks (module) (see illustration: DIN-track
assembly)

then push the next module onto the ﬁ eld bus / multipole
module

ﬁ x the module to the wall (as above)

connect the modules by pressing and turning the 3
Locking bolts (modules) to the right (90°). (Exception:
Terminal module)

install all the modules in the same way

Block open the blue connection brackets between all
the modules

install the FE connection on the front of the ﬁ eld bus
module

connect the FE contacts (8) via the FE rail

connect the FE rail to FE

→

B) Mounting on a DIN rail

DIN rail mounting

Locking pins (modules)

The FE contacts on the modules are connected via the
DIN rail that also has to be connected to FE.
The screw (9) on the ﬁ eld bus module is connected
to FE separately.

Proceed with rail mounting as follows:

install the modules from left to right

remove the blue connection bracket

unbolt the three pinlocks (module)

open the DIN rail mounting

place the module onto the DIN rail

push the module to the left up to the block (This point does
not apply for the ﬁ eld bus / multipole module.)

connect the modules by pressing and rotating the 3
locking bolts (modules) to the right (90°) (Exception:
Terminal module)

screw on the DIN rail mounting tightly,

install all the modules in the same way,

block open the blue connection brackets between all
the modules.

→