Burkert Type 2700 - Manual (Page 6)

4 - 2700
G
ENERAL
I
NFORMATION
english
Warranty conditions
This document contains no warranty promises. We refer in this connection to our General Conditions of Sale and Business.
The condition for the warranty is use of the unit for the intended purpose under the specified under the specified application
conditions.
Scope of delivery
Immediately after receipt of a shipment, make sure that the contents are undamaged and match the scope of delivery stated
on the packing slip.
If there are discrepancies, please contact immediately your Bürkert branch or our customer service:
Bürkert Fluid Control Systems
Service Department
Chr.-Bürkert-Str. 13-17
D-76453 Ingelfingen
Tel.: (07940) 10-111
Fax: (07940) 10-448
E-Mail: [email protected]
Symbol
The following symbol are used in these operating instructions:
marks a working step which must be performed
ATTENTION!
indicates information, which if not observed can result in harmfull effects on the health or the serviceability
of the unit.
NOTE Indicates important additional information, tips and recommendations.
Please observe the notes int hese operating instructions as well as the service conditions and permissible data which are
specified in the data sheets for the valve Type 2700 with pneumatic drive and the Top
Control, in order that the device will
function flawlessly and remain operable for a long time:
• Follow general technical rules when planning the application and operation of the unit!
• Installation and maintenance may only be performed by technical personnel provided with suitable tools!
• Note the accident prevention and safety precautions applicable during operation and maintenance of the unit!
• Always switch off the power supply before working on the system!
• Take suitable measures to prevent inadvertent operation or impermissible influences!
• Ensure a defined and controlled re-start of the process following an interruption of the electrical or pneumatic supply!
• Take the safety notes from the electrical part of the Top Control operating instructions.
• We cannot accept any liability if these instructions are ignored or impermissible interventions are made in the unit and the
warranty also becomes invalid on units and accessories!
Safety information
ATTENTION!
The warranty extends only to absence of faults in the valve Type 2700 with pneumatic drive and the
Top
Control. No liability will, however, be accepted for subsequent damage of any kind that may arise as a
result of the failure or incorrect functioning of the device.