Burkert Type 2511 User Manual
Page 2
2
2
InTended Use
Incorrect use of the cable plug Booster Type 2511 can be dan-
gerous to people, nearby equipment and the environment.
▶ Use according to the permitted data, operating conditions and con-
ditions of use specified in the contract documents and operating
instructions.
▶ The cable plug is used exclusively for the actuation of direct current
coils.
▶ Use the cable plug Booster type 2511 only in conjunction with the
designated coil models.
▶ Correct transportation, correct storage and installation and careful use
and maintenance are essential for reliable and problem-free operation.
▶ Use the device only as intended.
2.1 Restrictions
If exporting the device, observe any existing restrictions.
2.2 definition of term
In these operating instructions, the term “device” always refers to the
Type 2511.
1
OpeRaTIng InsTRUcTIOns
The operating instructions contain important information.
▶ Read the operating instructions carefully and follow the safety instruc-
tions in particular, and also observe the operating conditions.
▶ Operating instructions must be available to each user.
▶ The liability and warranty for the product / device are void if the operat-
ing instructions are not followed.
1.1 symbols
▶ Designates an instruction to prevent risks.
→
designates a procedure which you must carry out.
Warning of injuries:
Danger!
Imminent danger! Serious or fatal injuries.
Warning!
Potential danger! Serious or fatal injuries.
Caution!
Danger! Minor or moderately severe injuries.
Warns of damage to property:
note!
english
3
3
BasIc safeTy InsTRUcTIOns
These safety instructions do not make allowance for any contingencies
and events which may arise during installation, operation and maintenance.
Risk of electric shock!
▶ Before opening the device, switch off the power supply and secure
to prevent reactivation. The power supply may be switched on
again as soon as the device has been correctly installed and con-
nected and the cover has been attached with the screw.
▶ Do not touch PCB or components. Even when the power supply has
been switched off, components may still have a hazardous charge.
▶ Observe applicable accident prevention and safety regulations for
electrical equipment.
Risk of injury from unintentional activation!
▶ Take appropriate measures to prevent unintentional activation.
General hazardous situations.
To prevent injury, ensure that:
▶ The cable plug must not be used in potentially explosive areas.
▶ Do not make any external modifications to the device and do not put
any loads on the device.
▶ Installation and repair work may be carried out by authorized techni-
cians only.
▶ After an interruption in the power supply or pneumatic supply, ensure
that the process is restarted in a defined or controlled manner.
▶ The general rules of technology apply to application planning and
operation of the device.
english
4
note!
Electrostatic sensitive components/modules!
The device contains electronic components which react sensitively to
electrostatic discharge (ESD). Contact with electrostatically charged
persons or objects is hazardous to these components. In the worst case
scenario they will be destroyed immediately or will fail after start-up.
• Observe the requirements in accordance with EN 100015-1 to
minimise or avoid the possibility of damage caused by sudden elec-
trostatic discharge.
• Also ensure that electronic components do not come into contact
with a nearby power supply.
3.1 Warranty
The warranty is only valid if the device is used as intended in accordance
with the specified application conditions.
3.2 Trademarks
The brands listed below are trademarks of the corresponding
companies / associations / organizations
Ultrason
BASF AG, Ludwigshafen
3.3 Information on the internet
The operating instructions and data sheets for type 2511 can be found
on the internet at:
www.buerkert.com
Type
2511
english
Type 2511