EXP Computer DVD-780 (new revision) User Manual
Page 23
- 24 -
USING THE PCMCIA DVD-ROM CARD WITH THE MPEG-2 DECODER
CARD.
Windows 95/98 only
If you are using the PCMCIA DVD-ROM with MPEG-2 card such as
MARGI PCMCIA card, you should follow the instruction below:
1. Verify if the DVD-ROM install properly and try to read a DVD or CD-
ROM disk.
2. Insert the MPEG-2 card, this will start the Plug-and-Play device driver
installation procedure for Windows 95/98.
3. Provide the installation diskette for the MPEG-2 card when prompted.
4. Run “Setup” to install the DVD-to-go program.
5. Click on “Start”, go to “Program”, “Margi” start DVD-to-go.
6. The DVD-to-go will access the DVD-ROM and start to play the movie.
Please note that the “Display properties” screen color should be set at 256
color to start. You may adjust to higher color display later.