EXP Computer CD-940E - Manual (Page 22)

- 17 -
USE PCMCIA CD-ROM TO INSTALL OS/2 WARP
Before you begin, make a backup copy of the “Diskette for CD-ROM #1”
of OS/2 Warp.
1. Copy EXPCD2.FLT file from A:\OS2WARP to the Diskette for CD-
ROM #1. (You may copy EXPCD2.FLT to harddisk, then copy it to
the “Diskette for CD-ROM #1”).
2. Edit CONFIG.SYS file of the “Diskette for CD-ROM #1” by adding
the following line to the BOTTOM of the file,
BASEDEV=EXPCD2.FLT /P:1 /I:15
3. Insert “OS/2 WARP Installation Diskette” into drive A.
4. Restart your computer.
5. Follow the on-screen instruction to remove the “Installation Diskette”
from drive A and insert “Diskette for CD-ROM #1”. Then press
Enter.
6. The screen will prompt you to insert OS/2 CD into the CD-ROM
drive, then press Enter.
7. Follow the on-screen instruction to proceed with the installation.
When the OS/2 Installation is completed, you will be prompted to
shut down and restart your computer.