beautypg.com

EXP Computer CD-940E User Manual

Page 18

background image

- 13 -

SOFTWARE INSTALLATION FOR OS/2 WARP

Before installing PCMCIA CD-ROM device driver for OS/2 WARP, make
sure your computer is PCMCIA supported. If you are not sure about this,
please refer to the last part of this section for “ADDING PCMCIA
SUPPORT”.

AUTOMATIC INSTALLATION

To perform the automatic installation of PCMCIA CD-ROM for OS/2
WARP, follow the below steps,

1. Insert the device driver diskette into a floppy disk drive on your

computer.

2. Open OS/2 System.

3. Open Drives.

4. Select Drive A or B depending on which floppy drive containing the

device driver diskette.

5. Open “OS/2 WARP” folder.

6. Double-click on “INSTALL2.EXE” file.

7. A dialog box will be displayed for you to specify the OS/2 directory,

the I/O address for the PCMCIA CD-ROM and the IRQ number.
After specifying the OS/2 directory, press TAB to set the I/O port
and then the IRQ. The default setting of the I/O ports are (170-177,
376-377), and the default IRQ is 15. After completing the selection,
click on Install button to continue.

8. The rest of the installation should proceed automatically. At last, the

on-screen instruction will prompt to restart your computer to activate
the new device driver for OS/2 Warp.