EXP Computer CD-940E - Manual (Page 19)

- 14 -
MANUAL INSTALLATION
You may also manually install the PCMCIA CD-ROM OS/2 device driver
if the default setting conflicts with your system. Perform the following
procedure to complete the manual installation.
1. Copy EXPCD2.FLT file from A:\OS2WARP to the BOOT
subdirectory of OS/2 directory (for example: C:\OS2\BOOT.)
2. Add the following line to the BOTTOM of your CONFIG.SYS file:
BASEDEV=EXPCD2.FLT /P:1 /I:15
The parameters of EXPCD2.FLT are described as below:
/P is used to set the I/O ports, and the valid numbers are 1, 2, and 3.
Each number represents the I/O ports group of (170-177, 376-377);
(1E8-1EF, 3EE-3EF), and (168-16F, 36E-36F) respectively. The
default setting is
/P:1 .
/I is used to set the IRQ number, the valid IRQs are 3, 4, 5, 7, 9, 10,
11, 12 and 15, and the default setting is
/I:15 .
/V verbose mode, displays the initialization message. The default is
quiet mode.
Meanwhile, check if the following lines exist in CONFIG.SYS, if not, add
the following lines:
DEVICE=C:\OS2\BOOT\OS2CDROM.DMD /Q
IFS=C:\OS2\BOOT\CDFS.IFS /Q
DEVICE=C:\OS2\MDOS\VCDROM.SYS