EXP Computer CD-620 - Manual (Page 22)

USING THE PCMCIA CD-ROM AS A STAND-ALONE CD PLAYER
In a stand-alone audio CD player operation, the CD need either the AC adapter or
batteries for its power source, remember to set the POWER SOURCE SWITCH to
“DC/BATT”. Refer to the section titled “CD-ROM POWER SOURCE” for details.
It is not necessary to remove the PCMCIA interface card from the CD-ROM drive
when the CD-ROM is in stand-alone mode. You may store the card in the card
holder at the back panel of the drive.
The following control buttons will be used in stand-alone mode.
 
Power Button
•
Press the POWER button will turn on the PCMCIA CD-ROM in stand-alone
mode. Press the POWER button again will turn off the drive.
•
The PCMCIA CD-ROM will spin in a lower speed (single speed) in stand-alone
mode.
•
As another power saving feature, the PCMCIA CD-ROM will be automatically
turned off if it has not played for apporximately 40 seconds.
 
Play/Pause Button
•
Press this button will activate the drive to begin playing.
•
If the drive is in play state, pressing this button will make it pause.
•
This button will work in the audio CD playing mode only..
 
Next/Previous Button
•
In the play state, press the right edge of the button to skip to the next track.
•
Press the left edge of the button to skip to the previous track.
•
This button will work in the audio CD playing mode only..
 
Volume Control Knob
•
Use this knob to adjust the headphone volume.