EXP Computer CD-620 User Manual
Page 11
SOFTWARE INSTALLATION
SOFTWARE INSTALLATION FOR DOS/WINDOWS
Automatic Installation
The INSTALL program helps you install the device driver into your computer
easily. Please follow the instructions below to proceed with automatic installation.
1. Insert the device driver diskette into a floppy disk drive on your computer.
2. Change the working directory to the floppy drive containing the device driver
diskette by typing “
A:
”
or “
B:
” then press ENTER.
3. At the DOS prompt (A:\> or B:\>), type “
INSTALL
” followed by the ENTER
key.
4. Press ENTER or click on the OK button to continue. When the opening screen
appears, a dialog box will be displayed for you to specify the necessary
parameters:
•
Directory to install the device driver.
•
The DOS directory to specify the location of the MSCDEX driver.
•
The I/O port address
•
The IRQ number.
Enter the directory you select to install the driver and press the TAB key to
forward to the next field to indicate the DOS Directory. Press the TAB key again
to set the I/O port and then the IRQ. The default setting of the I/O ports are
(170-177, 376-377), and the default IRQ is 15.
5. After completing the selection, click on the Install button to continue.
Figure 8