1 introduction, 1 symbols and abbreviations, 2 general – DE DIETRICH ROE-II _ ROE-H User Manual

Page 3: 1 user's liability, 2 manufacturer's liability, 3 homologations, Introduction, 1 symbols and abbreviations 1.2 general, User's liability, Manufacturer's liability

13/01/2011 - 300019360-001-I

ROE-II / ROE-H

1 Introduction

1.1 Symbols and abbreviations

Caution danger
Risk of injury and damage to equipment. Attention must be
paid to the warnings on safety of persons and equipment

Specific information
Information must be kept in mind to maintain comfort.

Reference

Refer to another manual or other pages in this instruction
manual.

DHW: Domestic hot water
MIT: Indoor module fitted with a Diematic 3 control panel.
MHR: Indoor module fitted with a Oetronic 3 control panel.
HP or PAC: Heat pump
ROE-II: Reversible air / water heat pump
ROE-H: High temperature air / water heat pump for heating only

1.2 General

Congratulations on your choice of a high quality product. We strongly
advise you to read the following instructions in order to guarantee the
optimal operation of your appliance. We are sure that it will be entirely
to your satisfaction and will meet with all of your expectations.

1.2.1

User's liability

To ensure the optimum operation of your appliance, we strongly
recommend that you abide by the following instructions :
`

Read and follow the instructions given in the manuals provided
with the appliance.

Call on qualified professionals to:

- Carry out installation in compliance with the prevailing legislation

and standards

- Perform the initial start up
- carry out work on the appliance and the installation

Keep these instructions in a safe place close to the appliance.

Get your fitter to explain your installation to you.

1.2.2

Manufacturer's liability

The constructor's liability may not be invoked in the following cases:

- Failure to abide by the instructions on using the appliance,

- Faulty or insufficient maintenance of the appliance,
- Failure to abide by the instructions on installing the appliance.

1.3 Homologations

Electrical compliance / Marking

This product complies to the requirements to the european directives
and following standards:

- 2006/95/EC Low Voltage Directive

Reference Standards: EN 60.335.1 ; EN60335-2-40.

- 2004/108/EC Electromagnetic Compatibility Directive

Reference Standards: EN 61000-6-1 ; EN 61000-6-3.

- 97/23/EC Directive on pressurised equipment

Reference Standards: EN 378-2.

- 2006/42/CE Machinery Directive

Reference Standard: EN 378-2.