DE DIETRICH ROE-II _ ROE-H - Manual (Page 24)

24
ROE-II / ROE-H 13/01/2011 - 300019360-001-I
4.6.2 Electrical connections on the ROE-II / ROE-H heat pump
The apliances are designed in conformity with the Low Voltage
Directive and, more specifically, the following international standards:
EN 60335-1, EN 60335-2-40, EN 61000-6-1, -2, -3, -4.
CAUTION:
- Only qualified professionnals may carry out electrical
connections, always with the power off.
- If using an IT earthing system: Please contact us for further
information.
„ Connection to the mains
1. Remove the central screw.
2. Unclip at both ends.
3. Remove the cover.
A : Cable duct
: Single phase power supply
: Three-phase power supply
Keep to the polarity shown on the terminals: phase (L),
neutral (N) and earth 4.