DE DIETRICH KALIKO TWH 200E - TWH 300E - TWH 300EH - Manual (Page 18)

Model TWH 300 E TWH 300 EH TWH 200 E
Operating pressure bar (MPa) 10 10 10
Power supply voltage V 230 230 230
Circuit breaker A 16 16 16
Exchanger surface
m 2 - 1.00 -
Continuous output DT = 35 K (3) (4) litres per hour - 955.6 -
Flow rate over 10 minutes with DT = 30 K (3) l/10 mm - 420 -
Heating time (15-51 °C) (1) Hours 7 7 5
Qpr (1) kWh/24h 0.67 0.75 0.73
V40 (1) litres 357 358 240
Vmax (2) litres 388 383 281.9
Pes (2) W 34 36 30
Maximum length of the air connection Diameter 160 mm (5) m 25 25 25
R134a refrigerant kg 1.45 1.45 1.45
Weight (empty) kg 105 123 92
(1) Value obtained at an air temperature of 15°C and a relative humidity of 70%. Water inlet temperature at 15°C in accordance with EN255-3.
(2) Value obtained with an air temperature of 7 and a water inlet at 10 °C, as per EN16147 based on Specification LCIE N°103-15/B:2011
(3) Domestic cold water input at 10°C - Primary inlet temperature at 80°C
(4) Output: 34.1 kW
(5) The installation of suction and backflow conduits on the heat pump lessens its performance
3.4.2. Heating time of the DHW tank depending on
the air temperature
Scenario for complete heating of the DHW tank
A Heating time for a set point of 51°C
B Heating time for a set point of 62°C
Y Heating time (Hours)
X Air temperature (°C)
3.4.3. Max domestic hot water set point reached
by the heat pump depending on the air
temperature
Y Max domestic hot water temperature (°C)
X Air temperature (°C)
0
2
4
6
8
10
12
14
16
18
20
-5 0 5 10 15 20 25 30 35
Y
X
B
A
C003447-A
C003483-B
51°
-5 0 5 7 10 X
55°
65°
Y
3. Technical description TWH 200E TWH 300E TWH 300EH
16 03/02/2014 - 300026515-001-03