Datamax-O'Neil S2000i User Guide - Manual (Page 10)

6
Caution
 Do not REVERSE pull the paper out of the printer mechanism; this will cause permanent
damage to the print head.
3.3 Replacing the Inked Ribbon Cartridge
(Figure 1)

Open the paper supply door to access the ribbon cartridge

Remove the worn out ribbon cartridge by pressing with one finger at the location labeled “EJECT” on the
ribbon cartridge.

Insert the new ribbon cartridge in place and press at the extreme ends to secure it in place.

Tighten the ribbon by rotating the ribbed wheel clockwise on the ribbon cartridge.

Feed paper to insure that the paper passes through exposed ribbon and ribbon cartridge case.
3.4 Initial Power-Up and Self-Test
Once the Battery is charged and the paper is loaded perform an initial power up self-test.

Turn off all LED lights by pressing the OFF switch twice.

To start the self-test, press and hold the FEED switch then press ON

The printer will start printing the self-test messages.

Press the OFF or FEED to stop or cancel the self-test print.

The first few lines of self-test show the printer firmware version, the current printer settings and a list of any
optional or special features installed.

Also, sample demo lines are printed using internal printer fonts.