Datamax-O'Neil APEX Series Programmer’s Manual - Manual (Page 62)

56
Settings Value
Name APEX#, where # matches the printer model
Serial Settings 115200,8,n,2,n
USB Settings 57600, 8, n, 2, n
Discoverability mode Generally Discoverable
Connectivity mode GAP Connectable
Security mode Security Disabled
Fixed PIN 0 (Zero)
Set Master/Slave Policy Always let the connecting device select the master/slave role on incoming connections
Client Profile Disable Client Services
Server Profile Serial Port Profile Server enabled
Wireless Multi-drop mode disabled, forward to host only
Set Serial Interface RS232
Configuration over Bluetooth Enabled
Power Save mode Allow Sleep mode only
ESC sequence timing 500ms before ESC command & 500ms thereafter
The Bluetooth™ Interface Power Modification
The Bluetooth™ interface increases the battery power consumption by 50mA. To compensate for the increased power
demand, the trickle charge rate is modified to help extend the life of the internal battery cartridge. The printer
modification is such that the printer can be set to operate in either the MANUAL POWER OFF or CONTINUOUS ON
mode. For Dip Switch settings on Power Save mode please refer to the Dip Switch Table above.
Manual Power OFF Mode
For the printer to be in Manual Power OFF mode Dip Switch # 8 must be OFF. When demonstrating RF wireless
communication, turn the printer on by pressing the ON switch located at the front of the printer. The printer will remain
active waiting for the wireless print command. Pressing the ON switch again will turn the printer OFF. For each wireless
demonstration, turn the printer on by pressing the ON switch. Operation in this fashion will greatly extend the life of the
battery cartridge. Unless the ON/OFF switch is pressed the printer will stay ON until the battery drains completely.
Automatic Power OFF Mode
To have the printer automatically SHUT DOWN after a period of time, turn Dip Switch # 8 ON. The printer will turn OFF
after 99 seconds. The value of the default timer can be changed by using the command ESC M n1n2 0 CR command
described earlier in the manual. Once power is cycled the printer reverts to the default 99 second value.
Infrared Communications (Option)
Set Dip Switch 1 to ON position. The printer can be powered up by pressing the power switch. If no IrDA
connection is made, the printer will automatically power down to a lower power level to conserve battery life. It will
remain in a “sleep” mode until an IrDA connection is made, at which time the printer will “wake” and print the requested
data. Pressing the power switch again will turn the printer .