Datamax-O'Neil VMP SERIES AN-15 (Line Printer and Easy Print Modes) User Manual
Page 5

{CBT} CONFIGURE BLUETOOTH (BT)
PARAMETER MEANING
VALUES/FORMAT
ORIGINAL
MF2/MF3/2t/4t
RADIO READY
2t/3l/4t
A:
Required
n = Y
Required
n = N
Not Required
X
B:n Bondable
n = Y
Bondable
n = N
Not Bondable
X
C:n Connectable
n = Y
Connectable
n = N
Not Connect.
X
D:n Discoverable
n = Y
Discoverable
n = N
Not Discover.
X
E:n
Encryption turned ON
n = Y
Encrypt Data
n = N
No encryption
X
F:n
“Friendly Name” (BT Device
Name)
32 ASCII characters max
X
I:nnn
Inactivity Timeout
[Bluetooth will disconnect if there
is no BT traffic in nnn seconds]
nnn in seconds
default = 180 seconds
minimum = 60 seconds
X
P:
Passkey
[NOTE: Some devices with
limited keyboard require a
numberic passkey]
16 ASCII characters max
Default = “passkey”
X
S:
Name
32 ASCII characters max.
Default varies by printer type
X
W:nn
Watchdog timer to check module
nn in seconds. Default is zero
(no check). Recommended
value is 55s. Legacy – used
with older modules only.
X
{CIB} CONFIGURE IrDA BAUD
The CIB command requires data only to configure the maximum BAUD rate of any IrDA communications. It is best to set
this value to no more than 38.4K Baud – setting any higher can result in retries and actually slow down the resulting data
transfer rate. Note that this affects IrDA BAUD ONLY. All other infrared transmissions use the configured RS-232 baud
rate as the data transfer rate.
IrDA communications always begins at 9600 BAUD. This value changes the MAXIMUM value this IrDA baud rate can be
negotiated as two devices connect. This same command also contains a letter N or W. This changes whether the printer
will begin printing as soon as it has enough data (N for NO WAIT) or if it will wait for disconnect before beginning to print
(W for WAIT)
COMPLETE
COMMAND
VALUES/FORMAT
ORIGINAL
MF2/MF3/2t/4t
RADIO READY
2t/3l/4t
CIB:nm
n changes maximum IrDA BAUD rate:
3 = 9600 BAUD
4 = 19.2K BAUD
5 = 38.4K BAUD
6 = 57.6K BAUD
7 = 115.2K BAUD
m specifies whether the printer should wait for disconnect before
beginning to print
N = No Wait
W = Wait for disconnect
X