Datamax-O'Neil VMP SERIES AN-15 (Line Printer and Easy Print Modes) - Manual (Page 3)

CN:n
RS-232 Number of Data Bits
n = 7  7 data bits
n = 8  8 data bits (default)
X X
CP:n
Configure Parity
n = N  No Parity (default)
n = E  Even Parity
n = O  Odd Parity
X X
CR:nnn
RF Radio Power Down Timeout
nnn in minutes
nnn = 65536
 Never Time Out (default)
[Turns OFF the radio if there is no activity in nnn minutes.
Requires user to turn radio back on via button push before
communications can resume]
X
CS:nnn
Beeper ON or Off
n = y or Y  Beeper is ON
n = n or N  Beeper is OFF
X X
CT:nnn
System Timeout (Printer Sleep Timer)
nnn in seconds (default 10s – 60s)
nnn = 9999
 Never Time Out
[If there is no activity – communications or button pushes –
within this time the printer will “go to sleep” to save power. A
button push or new communications will wake up the printer
automatically] X X
CU:n
Paper Out Beep
n = 0  One Beep (default)
n = 1  Five Beeps
n = 2  Five Beeps repeated every 15s
n = 3  Five Beeps repeated every 30s
n = 4  Five Beeps repeated every 60s
[Set the printer to continuously remind user that paper needs to
be changed. Beep repetitions stop when printer goes to sleep]
X
TP:n
Set Test Print
n = 0  Normal self test (default)
n = 1  Special MAC address label
[When n is not zero, a special self test label will be printed.
After a special label is printed, performing another self test
within 10 seconds will print the normal self test]
X
COMMIT
Required after issuing one or more of the above commands to
write the configuration to flash and restart the printer
X X