Datamax-O'Neil VMP SERIES AN-15 (Line Printer and Easy Print Modes) - Manual (Page 2)

CD:nn
Configure Darkness of Print (a.k.a. burn adjust). The value of
nn = 0 is “normal plain paper”
nn = -25
 -25% (for very sensitive stock)
nn = -20  -20%
nn = -15  -15%
nn = -10  -10%
nn = -05  -5%
nn = 00  00 (default - for “regular” stock)
nn = 05  +5%
nn = 10  +10%
nn = 15  +15%
nn = 20  +20%
nn = 25  +25%
nn = 30  +30%
nn = 35  +35% (for high temp stock)
X X
CE:n
Battery Eliminator
n = y or Y  Battery Eliminator present
n = n or N  None (default)
[Battery Eliminator can be used to power the printer from a wall
charger]
X (4t only) X (4t only)
CF:n
Form Feed Active
n = y or Y  Act on Form Feed
n = n or N  Ignore Form Feed (default)
[The Form Feed character, 12 decimal or 0C Hex can
configured to be ignored]
Always ON X
CG:n
Beep when Charger first connected
N = y or Y  Beep
N = n or N  Do not beep (default)
X X
CH:n
RS-232 Handshaking
n = N  No handshaking
n = H  Hardware handshaking
n = S  Software handshaking
n = B  Both H/W and S/W (default)
X X
CJ:n
Job Status Reporting in Easy Print
n = y or Y  Job Status Report ON
n = n or N  Job Status Report OFF (def)
[The Job Status report, which issues a message via whatever
communications medium was used to send the job can show
successful job completion or if there was a problem such as
paper out] X
CL:nnn
Default Protocol
nnn = ESC  Line Printer Mode (default)
nnn = EZ  Easy Print Mode
nnn = EMC1  Custom 1
nnn = EMC2  Custom 2
nnn = EMC3  Custom 3
nnn = EMP1  PGL
nnn = EMZ1  CPCL
nnn = EMZ2  Cog
nnn = EMZ3  ZPL
X
X X
X
X
X
X
X
X
X
X