Answering system operation, At touch tone phone, Remote access commands – AT&T 2462 User Manual
Page 40

37
Remote Access Commands
(continued)
Function
Command:
End remote access call
Press
* 0.
Turn system off
Press
0 and the mailbox number;
the system announces,“The ITAD is
now off.”
Press
0 again to turn the
system back on.
Turn system on
When system is off, it answers after 10
rings and announces, “Please enter your
security code.”
Press
#, then
enter your four-digit security code.
Review announcement
Press
7, then the mailbox number.
The system plays the currently selected
announcement for the mailbox.
Record announcement
Press
8, then mailbox number.
After system prompt, record new
announcement for the currently selected
mailbox. Press
5 to stop. System plays
back announcement.
Change Answer Mode
Press
9, then the mailbox number
the system announces current answer
mode (Answer + Record or Answer
Only) for the selected line. Press
9
again to change the answer mode.
NOTE: The remote access call automatically ends if you don’t press a
key within 15 seconds (other than when recording or playing messages
or announcements).
ANSWERING SYSTEM OPERATION
AT TOUCH TONE PHONE
2462_00_1 ATT CIB 1/28 1/28/02 9:52 AM Page 37