CHIEF CM2L40 - Manual (Page 18)

CM2L40 Installation Instructions
18
IR-SE15 Programming
IR-SE15 Control Features:
• Carrier Frequency: 38KHz
• Protocol: NEC - Full Repeat
• System Code(s): 6E (Default) - Multiple Codes
Selected via Key-Press (see below)
To Change System Code:
1. Press and Release Key 3 + 7 (Enter Setup Mode)
2. Press and Release Key 10
3. Press and Release Key 11 - LED Blinks Twice
4. Select System Code - See Table Below
5. Press and Release Key 2 - LED Blinks 4 times
(Exit Setup Mode)
Figure 30
Table 2:
System
Code
Press +
Release
6E (Default) 10, 10
E1 10, 13
E2 11, 11
E3 11, 12
E4 11, 13
E5 12, 12
E6 12, 13
E7 13, 13
Table 1: IR-SE15 Control Codes
KEY FUNCTION HEX CODE
1 NOT USED N/A
2 NOT USED N/A
3 RAISE DISPLAY 07
4 NOT USED N/A
5 STOP 0A
6 NOT USED N/A
7 LOWER DISPLAY 0D
8 NOT USED N/A
9 NOT USED N/A
10 NOT USED N/A
11 NOT USED N/A
12 NOT USED N/A
13 NOT USED N/A
1 2
3
4
5
6
7
8
9
10 11
12 13