Acer Altos G610 - Manual (Page 69)

59
Label Description
CN1 For SAF-TE card use
CN2 For SAF-TE card use (or for terminator board)
CN3 SCSI 68-pin connector
CN4 Front power LED connector
CN5 I 2 C buffer connector
JP1 I 2 C buffer ID setting
JP3 Power connector a
JP4 Power connector
JP5 3-pin FAN connector
S1
Slot 1 ID switch b
S2 Slot 2 ID switch
S3 Slot 3 ID switch
S4 Slot 4 ID switch
S5 Slot 5 ID switch
SLOT1 SCSI slot 1 connector
SLOT2 SCSI slot 2 connector
SLOT3 SCSI slot 3 connector
SLOT4 SCSI slot 4 connector
SLOT5 SCSI slot 5 connector
a. For the SCSI backplane board's loading requirement, please insert an independent
power cable to each power connector on the backplane board. The power cable
should not connect to any other device.
b. When you use the LVD SCSI hot-swap cage to arrange your system hard drives,
please remove all the jumpers on each SCSI hard drive and use the switches on the
backplane board (S1~S5) to set the hard drive's ID.
AA G610.book Page 59 Monday, October 22, 2001 9:46 AM