Acer Altos G610 - Manual (Page 43)

33
Installing cage nuts
Cage nuts are use to secure systems and other components to the
vertical rails in the rack.
To install cage nuts:
1 Insert the lower lip of the cage nut over the bottom of the
opening at the back of a rail.
2 Insert the small end of the cage-nut installation tool through the
opening in front of the rail and hook the tool over the top lip of
the cage nut as shown below.
3 Push in the cage nut while rotating the tool up and pulling the
tool back toward you until the top lip of the cage nut snaps into
position.
4 Repeat this process to install the other cage nuts in their
appropriate locations.
Cage nut Supports the M6 metal screws
for securing server components
to the rack
Screw type and
part number
Figure Usage
AA G610.book Page 33 Monday, October 22, 2001 9:46 AM