CEMB USA K9 (B) User Manual
Page 8
I 0672
- 8
GB
5.2 - RESULT OF MEASUREMENT
►
Inside correction
Outside correction
After performing a balancing spin, the amounts of unbalance are shown on the digital readouts.
Digital readouts with LED lit up indicate the correct angular wheel position to mount the counterweights (12 o’clock
positi
on).
If the unbalance is less than the threshold selected,
0
is displayed instead of the unbalance; with
it is possible
to read the values below the threshold chosen.
Note : in the case of wheels with a diameter less than or equal to 13” and at temperature conditions near
0°, the wheel balancer automatically inserts a special measuring cycle composed of two
successive measurements. The accuracy of the unbalance values and the reliability of the wheel
balancer remain unchanged. This type of operation is reset each time the wheel balancer is started.
5.2.1 - STATIC UNBALANCE
►
It is selected by pressing
and is shown on the central display. The position is indicated on the displays 3 and 4.
5.2.2 -
►
MODIFYING SET DIMENSIONS
If the wheel dimensions have been entered incorrectly, the parameters can be modifi ed without repeating the balan-
cing spin by pressing :
access parameter modifi cation
→
(select
to modify: (a) distance, (b) width, (d) diameter
→
to obtain the new measurement
or:
pull out the gauge to repeat the measurement
→
to obtain the new measurement.