CEMB USA K9 (A) - Manual (Page 16)

I 0615 - 16
9
d
b
a
10
aI
aE
dE
dI
GB
6.3 - Manual dimension presetting (Use only in particular cases or for test)
6.3.1 - Steel wheel rims (use for setting dimensions in
AUTOCALIBRATION
)
►
►
- Setting:
To enable the setting, hold the button
down for more than 3 seconds, then select the dimension by pressing
the button again.
- Set the distance “a” between the inside of the wheel and the
machine
- Set the nominal width, normally indicated on the rim, or measure the
width “b” using the caliper gauge supplied (see fi g. 5e).
- Set the nominal diameter “d” indicated on the tyre.
6.3.2 - ALUS rims ►
0 gauge
- Setting:
To enable the setting, hold the button
down for more than 3 seconds, then select the dimension by pressing
the button again.
Note: Hold the button down for more than 2
seconds when the value of any one of the dimensions
appears on the display.
Note: not setting dE as it is automatic, dE = dI - 1”.
N.B.: This setting is also valid for the correction
modes indicated at “STATIC & COMBINED MODES”.