beautypg.com

4 - controls and components, 1 - manual distance measurement gauge ( c 61 ), 3 - automatic wheel positioning – CEMB USA C61 (D) User Manual

Page 6: 4 - control panel and display

background image

I 0184 - 6

GB

4 - CONTROLS AND COMPONENTS

4.1 - MANUAL DISTANCE MEASUREMENT GAUGE ( C 61 )

This gauge serves for manual measurement of the distance of the point of application of the counterweight

FI

from the machine.

4.2 - AUTOMATIC DISTANCE AND DIAMETER GAUGE ( C 61Z )

This gauge allow measuring distance of the rim from the machine and the diameter at the point of
application of the counterweight. The same gauge can be used to position correctly the counterweights
inside the rim, using the specifi c function (see

EXACT CORRECTION POSITION INDICATION

), that enables

display of the position used for measurement (for calibration, see

AUTOMATIC PRESETTING ( C61 Z )

).

The gauge may only be used with the weight-holder pincer fi tted.

4.3 - AUTOMATIC WHEEL POSITIONING

At the end of the run, the wheel is positioned in relation to external or static out-of-balance (when
selected).
Positioning is disabled automatically for wheels less than 13” in diameter.
Accuracy is approx. ± 20 degrees for wheels weighing up to 25 Kg.

4.4 - CONTROL PANEL AND DISPLAY

Fig. 4

1-2

Digital readouts, AMOUNT OF UNBALANCE,

inside/outside

3-4

Digital readouts, POSITION OF UNBALANCE,

inside/outside

5

Indicators, correction mode selected

6

Indicators, selection made

7

Push button, unbalance reading < 5 g (25 oz)

8

Push button, operator selection

9

Push button, selection of mode of correction

10

Push button, SPLIT (unbalance resolution)

11

Push button, FUNCTIONS MENU

12

Push button, menu selection confi rmation

13

Push button, cycle start

14

Push button, emergency/home

15

Push buttons, manual DISTANCE setting

16

Push buttons, manual DIAMETER setting

17

Push buttons, manual WIDTH setting

Note: - Press buttons only with your fi ngers. Never use the counterweight pincers or other pointed

objects.

- When the beep signal is enabled (see

OPERATION FUNCTIONS MENU

) pressing of any push button

is accompanied by a “Beep”.