CEMB USA ER60 (A) - Manual (Page 10)

10
1
2
3 4
5
Use and maintenance manual Rev. 09-2013
ENGLISH
5.1.2 Modifying set dimensions
If you enter the wheel dimensions incorrectly, you can
change them without having to repeat the balancing spin:
5.1.2.1 Standard correction method
Set the value of the dimensions in sequence:
b=width
d=diameter
a=distance
using the buttons .
Press the button to confirm the setting and go to
the next dimension.
Press the button at any time to interrupt dimension
setting and return to the main screen.
5.1.2.2 Correction method with adhesive
weights (ALU)
Set the value of the dimensions in sequence:
aI=inside weight distance
aE=outside weight distance
dI=inside weight distance
dE=outside weight distance
using the buttons .
Press the button to confirm the setting and go to
the next dimension. Press the button at any time to
interrupt dimension setting and return to the main screen.
5.1.3 Static & combined modes
To change the application position of the correction weights,
press the buttons 1-2-3-4-5 to select the type of weight
and the position where you want to apply it.
The combinations of correction weights vary based on the
type of dimensions acquired.
Standard correction methods
STATIC:
▪ Combined balancing:
Correction methods with weights inside the rim (for
light alloy rims)
▪ adhesive weight on the outside (inside the rim)
▪ adhesive or clip-on weight on the inside:
Use of the wheel balancer