Acnodes 17" TFT Expandable Intel Core 2 Duo Industrial Panel PC with 2 PCI PC 8172 - Manual (Page 60)

PC 8172 User’s Manual
50 Phoenix-Award BIOS Utility
to restore the system when a “wake up” event occurs.
a Run VGABIOS if S3 Resume
When this item is set Auto, the system will run VGA BIOS if it is
reaumed from the S3 state.
a Power Management
This option allows you to select the type (or degree) of power
saving for Doze, Standby, and Suspend modes. The table below
describes each power management mode:
It is maximum power savings, only available for SL
CPUs. The inactivity period is 1 minute in each mode.
Max Saving
It sets each mode. Select time-out periods in the PM
Timers section.
User Define
It is minimum power savings. The inactivity period is 1
Min Saving
hour in each mode (except the hard drive).
Default value Disabled
a Video Off Method
This setting determines the manner in which the monitor is blanked.
Turns OFF vertical and horizontal
synchronization ports and writes blanks to the
video buffer
V/H
SYNC+Blank
Select this option if your monitor supports the
Display Power Management Signaling (DPMS)
standard of the Video Electronics Standards
Association (VESA). Use the software supplied
for your video subsystem to select video power
management values.
DPMS
System only writes blanks to the video buffer.
Blank Screen
a Video Off In Suspend
This item defines if the video is powered down when the system is
put into suspend mode.
a Suspend Type
If this item is set to the default Stop Grant, the CPU will go into Idle
Mode during power saving mode.
a Moden Use IRQ
If you want an incoming call on a modem to automatically resume
the system from a powersaving mode, use this item to specify the
interrupt request line (IRQ) used by the modem. You might have to