PA Industries Edge Servo Roll Feed SRF-100(for Serial Numbers 7610697 and higher) - Manual (Page 16)

WARNING
This equipment offers various means of operating or
controlling machines. The operator must not be in or
near the point-of-operation of the machine, or the
operating parts of any equipment installed on the
machine, or bodily injury could result. The EMPLOYER
must post adequate warning signs onto the machine with
proper warnings for his machine and the specific
application to which the machine and equipment are
being applied.
Occupational Safety and Health Act (OSHA) Sections
1910.211, 1910.212, and 1910.217 contain installation
information on the distance between danger points and
point-of-operation guards and devices. No specific
references have been made to which paragraph
of OSHA 1910.211, 1910.212, 1910.217, or any other
applicable sections because the paragraphs may change
with each edition of the publication of OSHA
provisions.
All equipment manufactured by us is designed to meet
the construction standards of OSHA in effect at the
time of sale, but the EMPLOYER installs the equipment
so the EMPLOYER is responsible for installation, use,
application, training, and maintenance, as well as
adequate signs on the machine onto which this
equipment will be installed.
Remember, OSHA says that the EMPLOYER must use
operating methods designed to control or
eliminate hazards to operating personnel.
It shall be the responsibility of the EMPLOYER to
establish and follow a program of periodic and regular
inspections of his machine to insure that all their parts,
auxiliary equipment, and safeguards are in a safe
operating condition and adjustment. Each machine
should be inspected and tested no less than weekly to
determine the condition of the machine. Necessary
maintenance or repair of both shall be performed and
completed before the machine is operated. The
EMPLOYER shall maintain records of these inspections
and the maintenance work performed.
Our Company is not responsible to notify the user of
this equipment of future changes in State or Federal
laws, or construction standards.
SAFETY PROGRAM
Accident free operation will result from a well developed,
management sponsored and enforced safety program.
Of vital importance to any successful program is the
proper selection of guards and devices. However, there is
no safety device that will bring "automatic" safety to
your operation.
Of equal importance to this proper selection of the guard
and the device is the training of your personnel. Each
person must be trained as to the operation of the guard
or safety device, highlighting why they have been
provided on the equipment. Rules for safe operating
should be written and enforced at all times. A final
major concern of an effective safety program is regularly
scheduled inspection and maintenance of all of the
equipment.
To ensure continued safety at all times, top management,
line supervision, safety engineers and all employees must
assume their proper share of the responsibility in the
program. Only as a group, one that knows your own
operation and its problems, can you carry out an
effective safety program.
To assist you in the development of and continued use
of safety programs, many safety minded groups have
made guidelines available to you. However, you must
know when and how to apply these guidelines. The
manufacturer provides information to assist you in
properly adjusting and maintaining your equipment.
There is no shortcut to proper safety; therefore, it is
recommended that you comply with their
recommendations at all times.
WARRANTY
We warrant our new parts against defects under normal
use and service for a period of 12 months after date of
shipment. Our obligation under this warranty is limited
to replacing or repairing (at our option) the defective
part without charge, Freight On Board (FOB) our plant
in Bloomfield, Connecticut. The defective part must be
forwarded to our plant, freight prepaid, for our inspection
prior to replacement or repair. EXCEPT AS EXPRESSLY
PROVIDED HEREIN, THIS WARRANTY IS IN
LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING A WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. Furthermore, the seller does
not warrant or represent that the equipment complies
with the provisions of any law, particularly including the
Occupational Safety and Health Act of 1970, and
regulations promulgated thereunder. In no event shall we
be liable for special, indirect incidental or consequential
damages, however rising.
16
P/A INDUSTRIES INC. 522 Cottage Grove Road • Bloomfield, Connecticut 06002-3191 U.S.A.
Toll Free 1-800-243-8306 • Worldwide 1-860-243-8306 • Fax 1-860-242-4870
Website http://www.pa.com • E-Mail [email protected]
FORM 1037 12-00