MoTeC PDM30 - Manual (Page 15)

12 Installation
CAN Keypads
The CAN Keypads continuously communicate with the PDM which will
prevent the PDM from entering its low power standby mode.
Options for powering the keypads include:
- Configuring the PDM to always power the keypads.
This allows buttons on the keypads to be used for master startup
functions, but the PDM would never enter standby mode.
To minimize battery drain, the isolator would need to be turned off (eg.
during vehicle transport or storage)
- Wiring a master switch or ignition key input to the PDM.
All outputs (including the keypad power) would be configured to turn
off when the master switch or key is turned off.
This allows the PDM to enter standby mode, minimizing battery drain.
PDM Manager Software Installation
The PDM Manager software is used to:

Change the PDM configuration

Monitor the PDM operation including the output currents and
diagnostics

Test the outputs by manually turning them off and on

Set and unlock security password

Update the firmware
PC Requirements
PDM Manager runs under Windows XP or Vista operating systems. The
minimum recommended PC specification is a Pentium 90 with 16 MB RAM
and a USB port.
Installing PDM Manager Software

Go to the MoTeC website at www.motec.com and navigate to
downloads/software/latestreleases/PDM Manager software
OR Locate PDM Manager software on the MoTeC Resource Disc

Save the selected file in your preferred location (for example desktop)

When downloading is finished, double click on the file and select run

Follow the instructions on the InstallShield Wizard