Dialight SafeSite L-864 Red LED Class I, Div 2 Medium Intensity Beacon - Manual (Page 10)

Document No.
9100-127-1438-99 Rev A
March 31, 2011
_____________________________________________________________________
_____________________________________________________________________________
Dialight Corporation 1501 Route 34 South Farmingdale NJ 07727
Tel: 732.919.3119 Fax: 732.751.5778 Web: www.dialight.com
10 of 13
Step 5 Rotate the light engine downwards to approximately 10 degrees from the
closed position. The key should line up with the keyway on the hinge and
allow for the light engine to be pulled off of its pins.
Figure 6 – Light Engine Install/Removal (Dome and cantilever not
shown for clarity)
Step 6 Slide the new light engine onto the pins to line it up. Rotate it to
approximately 10 degrees from closed to again line up the keyway. Push
the light engine past the key until it clears and than rotate it back to the
open position.
Step 7
Reconnect the inline connector between the light engine and power
supply, followed by the grounding strap.
Step 8
Rotate the light engine down to the closed position and secure the two
latches to complete installation. Apply power to ensure the beacon lights
up correctly.