Dialight SafeSite LED Emergency Bulkhead - ATEX/IECEx - Manual

Dialight – LED Solutions for Industrial and Hazardous Applications
Tel: +44 (0)1638 665161 – Fax: +44 (0)1638 660718 – www.dialight.com
Technical Data:
9 LED VERSION 18 LED VERSION 27 LED VERSION
Category of application:
Ex d e mb IIC T6 Gb
Ex tb IIIC T85°C Db
IP66/67
II 2GD
IECEx / ATEX IECEx BAS 10.0051X / Baseefa10ATEX0092X
Rated Input Voltage: 110/120VAC 50/60Hz or 230/240VAC 50/60Hz 230/240VAC 50/60Hz
Rated Input Current:
140mA at 110V
85mA at 230V
250mA at 110V
130mA at 230V
180mA at 230V
Operating Ambient
Temp.
0°C to +50°C
(optional -20°C to +50°C)
-20°C to +40°C
Housing Material: LM6 Aluminium (Copper free)
Housing Colours: RAL 7001 (optional RAL 7011 / RAL 8011 / RAL 9005 / RAL 8019)
Storage Temp. original
packaging:
-20°C to +60°C
Dimensions: See Figure.1
Protection Glass: Toughened Glass Frosted or Clear.
Cable Entries: Standard 2 OFF M20 x 1.5mm (Other entry options may have been supplied)
Tightening Torques See Table
Weight: 5.4kg (11.9 lbs) 5.4kg (11.9 lbs) 6.1kg (13.50 lbs)
WEA Series LED fixture for
hazardous areas.
Self-contained Emergency
Version Operating Instructions
Important Information:
These instructions contain important safety information, read and follow them carefully. Dialight will not accept any
responsibility for injury, damage or loss which may occur due to incorrect installation, operation or maintenance.
A80-000847 Issue B
Safety Instructions:
The installation, operation and maintenance must be carried out by an electrician suitably trained in hazardous areas and with
knowledge of increased safety explosion protection IEC 60079-14
•
The technical data indicated on the LED fixture are to be observed.
• Changes of the design and modifications to the LED fixture are not permitted.
•
Repairs must only be carried out by a qualified electrician with hazardous area knowledge.
• Only genuine Dialight Europe Ltd replacement parts must be used when unforeseen repairs are required.
•
Observe the national safety rules and regulations during installation.
• Do not keep these operating instructions inside the LED fixture during operation.
• Do not open the LED fixture when energised.
• Wait 10 minutes before opening after de-energising the LED fixture.