DE-STA-CO 722 INTERMITTOR - Manual (Page 22)

20
FOLLOWER NO. FM-100 & FS100 - FS-400
DISASSEMBLY:
Remove locknut, setscrew and follower.
ASSEMBLY:
Clean the follower and stud hole in the
roller gear hub and inspect for
elongation, which could cause backlash
by failing to support the stud at the top.
Apply a light coat of assembly grease to
a new cam follower and install it firmly
against seat; loosen and retighten.
Install setscrew, tighten sufficiently to mark follower stud with setscrew point and remove setscrew.
Remove cam follower and drill a setscrew seat at the marked position deeply enough to make seat
diameter equal to setscrew diameter.
Clean cam follower, coat with grease and install firmly against seat; check that the drilled seat lines up
with the setscrew hole. Assemble setscrew and locknut and tighten firmly.
SECTION 8: Repair and Replace (continued)
FIGURE 8
FOLLOWER NO. 5202M; 5204T; 5304M; 5306M
DISASSEMBLY:
Remove flat head screw,
bearing cap and outer race
of follower.
Remove outer and inner race.
(If inner race is tight on the
stud, drive a wedge between
the flanged end and the roller
gear hub to remove it.)
ASSEMBLY:
Clean stud and bearing cap and apply light coat of assembly grease to stud; install inner race firmly
against hub; install outer race with identifying numbers on outboard side; install bearing cap over
locating pins and tighten in place with self locking flat head cap screw.
FIGURE 9