DE-STA-CO 722 INTERMITTOR - Manual (Page 21)

19
SECTION 8: Repair and Replace (continued)
FOLLOWER NO. F-50 THROUGH F-400
DISASSEMBLY:
Remove setscrew and pull cam follower
from hole using a draw hammer secured
in tapped hole.
ASSEMBLY:
Clean the follower stud hole in the roller
gear hub and inspect for elongation,
which could cause backlash by failing to
support the stud at the top.
Place a socket head screw in pull hole
and strike its head - do not strike the
follower end cap when installing.
Apply a light coat of assembly grease to a new cam follower, orient so the setscrew and seat are in
line and install lightly against shoulder.
FOLLOWER NO. FM-50; FM-62; FM-75
DISASSEMBLY:
Remove jam nut, setscrew, follower and
nylon plug.
ASSEMBLY:
Clean the follower stud hole in the hub
and inspect for an out-of-round condition,
which could cause backlash by failing to
support the stud at the top.
Apply a light coat of assembly grease to
a new cam follower and install it firmly
against seat; loosen and retighten. Install
new nylon plug and tighten setscrew and
jam nut in place.
FIGURE 7
FIGURE 6