DE-STA-CO 722 INTERMITTOR - Manual (Page 10)

8
SECTION 4: Installation
These units are manufactured to meet a specific set of design parameters. Any change to the load,
size of dial, or speed of the camshaft may require a size change. No change can be made without
affecting other performance characteristics of the unit and, therefore, should not be done without
consulting the factory.
4.1. To install the unit:
4.1.1. Rotate input shaft so cam is in center of dwell (see Figure 3).
4.1.2. Mount the Intermittor into position on a rigid base and secure with the largest size
bolts that will fit through the mounting holes.
4.1.3. Align the Intermittor with respect to the station positions before tightening bolts and
doweling. Use a dial indicator or other appropriate tool to insure alignment.
4.1.4. Tighten all mounting bolts securely and uniformly.
FIGURE 3