DE-STA-CO 722 INTERMITTOR - Manual (Page 20)

18
SECTION 8: Repair and Replace
8.1 Cam Follower Replacement
8.1.1. Rotate camshaft to mid-dwell position. (See Figure 3)
8.1.2. Drain oil and remove front access cover.
8.1.3. Stand unit on end and remove bottom access cover to expose cam follower stud
locking fastener.
8.1.4. Determine cam follower design for your unit, and refer to the following instructions
(Figures 6 through 9). Then continue with step #8.1.5. below.
8.1.5. Clean sealant from access cover(s) and surfaces on housing.
8.1.6. Install access cover(s) with silicon rubber sealant, and tighten screws evenly.
8.1.7. Refill with oil.