DE-STA-CO 722 INTERMITTOR - Manual (Page 13)

11
SECTION 5: Adjustments
The Intermittor is a solid mechanical, backlash-free mechanism. There are no adjustments required on
the Intermittor during installation unless it is furnished with a torque limiting device or a motor drive
package equipped with speed control. After the Intermittor has been installed and set up with the users’
load in place, it will be necessary to check these items for proper adjustment & settings.
NOTE: Drive should be in center of dwell and dowel pinned to base before installing dial, as
previously mentioned in 4.1.1. & 4.1.5.4.
5.1. FSC… Ferguson Slip Clutch Location Map
FIGURE 4
1. Housing
3. Body & Cone
4. Thrust Bearing
5. Silicon Spring
6. Adjusting Nut
7. Guide Pin
8. Spool
9. Ball Plunger
10. Liner Bushing
11. Setscrew
12. Pipe Plug