Camco D-Power 7 - Manual (Page 18)

D - P O W E R
S E R I E S
USER MANUAL
D-POWER 7
P.17
4.2 Indicators
4.2.1 On LEDs (multifunctional)
Under normal operation, after the amp has started, the green On LEDs are
permanently lit. A variety of different sequences of flashing LEDs are used
to indicate other operating states and errors in the relevant channels of the
power amp (See 6.1 Flashing sequences for On LEDs).
4.2.2 Signal LEDs
The green Signal LED is illuminated when the voltage level at the output
reaches approx. 4 V; this corresponds to a power of approx. 4 W over a
4 Ohm resistor.
4.2.3 I-Out LEDs
The brightness is proportional to the output current in the corresponding
channel.
4.2.4 Clip LEDs (multifunctional)
The colour of the bi-coloured LED changes between orange and red, de-
pending on the clip intensity. Orange indicates light clipping, red indicates
heavy clipping.
4 OPERA
TION